![spears and munsil calibration disk spears and munsil calibration disk](https://m.media-amazon.com/images/I/71js19NllXL._SL1400_.jpg)
- Spears and munsil calibration disk how to#
- Spears and munsil calibration disk manuals#
- Spears and munsil calibration disk windows#
Use your Blu-ray remote to select the Chroma Alignment pattern. Integrated rear projectors can only be focused by a trained technician. Flat-panel displays like LCD, OLED or plasma do not have focus. If your display is a front projector (an independent projector that projects onto a separate screen, as opposed to an integrated “rear projector” where the screen and projector are all in the same box), you will want to check the focus, as small focus errors can mask issues and artifacts. The menus are always in HDR, so moving back and forth from SDR patterns to the menu causes the display to switch back and forth between HDR and SDR modes. Using left and right arrows to move to the previous or next pattern is especially useful while viewing SDR patterns. To return to the menu from a pattern, you can press the “enter” button or the “top menu” button. While viewing a pattern, you can use the left and right arrows to move to the previous or next pattern without needing to return to the menu. If the display doesn’t give exact numbers for each setting, just write down their visual position as best you can, like “far left” or “dead center” or “two notches below far right.” Write down every menu item, not just the five main ones mentioned above. It is a good idea to write down at this point the current video setting values so if needed you can reset everything and start over.
Spears and munsil calibration disk how to#
Make sure you know how to bring up the video settings menus and reach the Brightness, Contrast, Color, Tint, and Sharpness controls. You can do this while the system is warming up it won’t cause any harm to bring up menus and so forth during the warm-up time. Take some time to familiarize yourself with the display remote.
![spears and munsil calibration disk spears and munsil calibration disk](https://www.soundandvision.com/images/styles/600_wide/public/111111-SetupDiscs.jpg)
facing the screen directly rather than at an angle, but if that’s not practical use your actual movie-watching location don’t calibrate from the center unless that’s where you normally sit. If possible, that location should be centered, i.e.
![spears and munsil calibration disk spears and munsil calibration disk](http://cdn.avsforum.com/2/24/2405f760_vbattach174727.jpeg)
![spears and munsil calibration disk spears and munsil calibration disk](https://i.ebayimg.com/images/g/kpYAAOSwxJJdKEsp/s-l300.jpg)
Spears and munsil calibration disk manuals#
Spears and munsil calibration disk windows#
If there are windows in the room that let in sunlight and you tend to watch movies at night, then the calibration should also be performed at night. In general, video looks best when the room is as dark as possible, but it’s most important to duplicate the real lighting conditions you will be watching under. Perform the calibration under the same lighting conditions you generally use to watch quality material like movies. Reading these is not required to get a good picture, but it’s helpful for understanding the theory behind each test pattern. Before beginning you may want to review the detailed background articles about the basic adjustments found on the Spears & Munsil web site. It’s important to be methodical and careful while performing the adjustments, and to understand what to look for in each test. Using the tests on the Spears & Munsil UHD HDR Benchmark to adjust your display is not difficult and performing the basic calibration should take 30 minutes or less.